|
|
Post by jvanbeek on Mar 24, 2010 19:47:37 GMT -5
I've powder coated my motor black. Is there anyplace where I can buy black fasteners that will not rust, or am I better off spraying them black after the motor is put back together?
Thanks
jvanbeek
|
|
|
|
Post by 5twins on Mar 25, 2010 0:48:32 GMT -5
I just spray paint the heads with barbecue black. I polish my cases but I like the contrast of the black screws against the shined cases.
|
|
|
|
Post by dogbunny on Mar 25, 2010 9:49:35 GMT -5
I black out my fasteners using a good #2 sable brush and a $1 jar of Testor's model enamel. It's good for frame touch-ups too. If I was going to black out engine fasteners there are lots of different brands and colors of high-temperature brush-on enamels available.
|
|
|
|
Post by txpowdercoating on May 3, 2010 21:15:51 GMT -5
Just get your powdercoater to clean and coat the bolt heads and nuts to match.
Timothy
|
|
|
|
Post by grepper on May 4, 2010 9:25:52 GMT -5
Isn't there some rule that says you can't use the board to advertise your services?
|
|
|
|
Post by lordeoin on May 4, 2010 10:03:58 GMT -5
I have used Cold Blue for firearms to blue Bolts. The more you dip them, the darker they get. Then oil them. Most sporting goods stores carry it.
|
|
|
|
Post by txpowdercoating on May 6, 2010 19:53:16 GMT -5
Isn't there some rule that says you can't use the board to advertise your services? probably, I dont see where I have been pimping the biz, I simply offer sound educated advice, it is a powdercoating section and by all means, thats definately something I do know a bit about and don't mind sharing the knowledge. Isn't that what these forums are for? Timothy |
|
