dbeck
New Member
Posts: 7
|
Post by dbeck on Aug 13, 2011 19:11:21 GMT -5
I am wiring up my bike for first startup. I have a push button kill switch off a crf 450 i would like to use . Will this work ? I am running PM ignition with pamco and no battery .
This switch has 2 wires ,one comes out of the switch and one that grounds to its clamp . Would this be used to ground out the coil ?
|
|
|
|
Post by mrriggs on Aug 13, 2011 21:16:58 GMT -5
Yep, wire it to the negative side of the coil primary.
It's also a good idea to extend the ground wire from the clamp so it runs down and connects to the frame. Grounding through the bars is sketchy, unless you already have a solid ground wire run to the bars.
|
|
dbeck
New Member
Posts: 7
|
Post by dbeck on Aug 13, 2011 22:02:14 GMT -5
Yep, wire it to the negative side of the coil primary. It's also a good idea to extend the ground wire from the clamp so it runs down and connects to the frame. Grounding through the bars is sketchy, unless you already have a solid ground wire run to the bars. Thats Great Mrriggs , I thought there was problably a way to use it, but this wiring buisness is all new to me. As the pile of scrapped wire laying all over the garage floor will attest. Thanks for the help ! |
|
